Gary’s SawBuck

Gary e-mailed photos of his completed sawbuck and it looks fantastic. He had some very specific requirements and modified the plans a bit. His description is here:

We are full-time motor homers in a 38′ Holiday Rambler Endeavor diesel pusher where everything has a place and everything MUST be in its place. So a saw buck must be small, fairly lightweight and portable.

I changed the angle of the 2″ X 4″s to be 35 degrees, instead of 45 degrees, in the “crotch” that holds the logs. That made the “footprint” a little narrower, but it is still stable. The wood that I cut into lengths are almost always tree limbs and never bigger than 9″ or 10″ in diameter.

Per your suggestion, I used a 1″ X 6″ oak board to “tie” the two sets of “legs together, with 2-1/2″ Kreg pocket screws. After I glued (Gorilla glue) the 1-1/4” pivot dowels into the legs, I “pinned” the pivot dowels with a 5/16″ X 3-1/2″ cross-dowel to prevent the pivots from ever “spinning” in the leg.

I’ve had a stroke and am mildly handicapped, so simple projects like this are about the limit of my abilities. Prior to my stroke, I’ve built furniture, garages, houses, etc. But, I really enjoyed this project.

Gary “FritoBandito” F.

P1000671P1000674P1000677

Thanks for the photos Gary! I love to see how these projects turn out. They are all a little different and all wonderful.

Here are the original sawbuck plans.

Be Sociable, Share!

Leave a Reply

Your email address will not be published. Required fields are marked *